技术文章
TECHNICAL ARTICLESS78-13系列机床减振垫铁适用范围:大中型普通压力机、剪板机、折弯机等。
Application :
large and medium-size forcing presses、guillotine shears、bending machines and etc.
图为北京市长城机床附件有限责任公司S78-13系列机床减振垫铁
S78-13系列机床减振垫铁产品特点:
1、 安装机床不需埋设地脚螺栓。
2、 调整机床水平方便、迅速。
3、 缩短安装周期,费用节省。
4、 隔振、减振、降低噪音。
5、 耐油性,耐腐蚀性强
Feature of product:
1.Machines are stationary on floor without anchors.
2.It is convenient and quick to adjust the level of machine.
3.The cost and time of installation can be greatly saved.
4.Vibration and noise can be reduced and isolated by using this product.
5.It can resist oil and corrosion greatly.
S78-13系列机床减振垫铁使用方法:
1、 将所需垫铁放入机床地脚孔下,穿入螺栓。
2、 旋转螺栓调整机床水平。
3、 调整机床水平后,旋紧螺母即可。
How to install:
1. Place the fitting mounts under the anchor holes of the machine. Insert the bolts into the screw holes of the mounts.
2. Screw the bolts for adjusting the level of the machine.
3. Tighten the nuts after adjust the level of machine.
S78-13系列机床减振垫铁注意:
因为橡胶的蠕变现象,在垫铁*次使用时,两星期以后再调节一次机床水平。
Note :
The level of machine should be readjusted after two weeks in use because the rubber may creep when it is used firstly.
S78-13系列机床减振垫铁技术参数及选用表:
Specification and chart for choice:
选用垫铁承载力方法:机床自重÷地脚孔数量=单件实际承载
How to choose: Total weight of machine (Kg)/Number of anchors of the machine =The actual resisting load of the mount F(Kg)
型 号 model | 尺寸(mm) 长×宽×高 | 可调高度 (mm) | 螺纹 (mm) | 螺栓长度 (mm) | 单件重量 (kg) | 单件 zui大承载 (kg) |
S78-13-01 | 290×230×85 | 15 | M24×1.5 | 180 | 24 | 6000 |
S78-13-02 | 350×280×95 | 20 | M30×2 | 180 | 38 | 8000 |
S78-13-03 | 407×318×126 | 25 | M30×2 | 180 | 60 | 10000 |
S78-13-04 | 500×410×135 | 30 | M39×2 | 220 | 100 | 15000 |
扫一扫,添加微信
服务电话:
0317-8770888 北京市昌平区回龙观朱辛庄320号 1007136148@qq.com